![]() ![]() ![]() Jeep Grand Cherokee Inner Tie Rod Torque Spec : 50 ft-lbs Jeep Grand Cherokee Outer Tie Rod End Torque Spec : 55 ft-lbs When putting the tie rod onto the vehicle the tie rod end nuts get tightened down to 55 ft-lbs.īe sure to install new cotter pins to ensure that vehicle safety is maintained. Whenever steering components are changed I recommend having an alignment done after the job to ensure the vehicle is in goodįunctional condition. This inner tie rod screws into the power steering rack and can be torqued down to 50 ft-lbs.īe sure to inspect and measure your old tie rods so that the new ones can be installedĬorrectly. The outer tie rod itself connects with another inner portion of the rod through the use If any of the steering rods are looseīe sure to replace them appropiately. Tie rod is apart of an entire rod system which controls the steering of the vehicle. Once the tire is off you can now access the old tie rod and remove it for replacement. Once the vehicle is in the air you can remove the corresponding tire for the side that you want to change the This can beĭone by raising the vehicle up by either the use of a floor jack or a vehicle hoist. To install a new tie rod on a Jeep Grand Cherokee you must first remove the old one from the vehicle. Stabilizer Frame Bracket Bolt Torque Spec ![]() 2002 Jeep Grand Cherokee Front End Torque SpecsĬlick the area you are looking for! Front Steering Torque Specsįront Wheel Hub Bearing Bolts Torque Specįront Lower Control Arm to Axle Torque Specįront Lower Arm to Frame Bolts Torque Specįront Upper Control Arm to Axle Torque Specįront Upper Arm to Frame Bolts Torque Specįront Track Bar Bracket Bolts Torque Specįront Track Bar Bracket Support Bolts Torque Spec ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |